It says weak or no signal.
Samsung smart tv weak or no signal check the antenna cable connection.
Is your samsung tv connected to a surge protector or power strip.
Have you tried to power reset your tv unplugging the power for 1 2 minutes then plugging it back in.
However when i connected to my indoor antenna it still shows no signal.
In some cases if you.
2 run auto program menu channel.
I do not know if.
You connect the antenna cable to the ant in vhf uhf jack on the back of the tv if your antenna cable ends in bare wire or u hooks you can buy an adaptor that will let you connect it to the ant in jack.
Hi samsung team i recently purchased a samsung tv qe55q6fna.
Weak or no signal.
This is often a result of either the tv box being powered off not being properly connected to the tv or the tv being set to the wrong input.
Netflix and other aps which runs on internet works perfectly well.
Also when i go to settings and then broadcast the broadcast option is greyed out.
The samsung tv will not turn on.
2 please apply the auto tuning and check whether tv is working well.
On the screen the message is.
Previously it worked fine.
Setup was success with wifi and smart things app from my samsung phone.
I have not seen this before as my cable box is connected and turned on.
When i go to the source menu there is no source for the antenna.
If i click on the tv option it brings me to tv plus instead of prompting me to scan for over the air channels.
1 connect the rf cable wire into the coaxial cable port of your cable box satellite receiver.
Check the antenna cable connection run auto progream menu channel.
Adaptors are available at electronics stores.
I am trying to hook up an antenna to my samsung 4k hd smart tv.
1 check antenna cable connection.
I read more.
I have an hd flat screen tv and when i turn it on it says no signal.
No digital channels or radio channels found.
Indoor antenna is also new.
If you still see no signal on your tv screen see the next step below 3 if you have reset the cable or sat box and still have the no signal unplug the cable going from the tv to your cable or sat box remove the hdmi cable or other cables from your cable tv or sat set top box keep the cable unplugged for 2 to 3 minutes.
Please let me check that.